Click on the image to check the artwork
Features of biomass fuel wood sawdust pellet making mill production line
1.It is make the pellet from feed,sawdust,rice hull,bark,etc.The feed pellet is for the livestock and poultry. 2.With full stainless steel door,flume,and pull cutter which is convenient,reliable. 3.Permanent magnet device with high performance.Customize pellet mill with double layers or three layers 4. It is widely used to make pellets from light substance, such as wood chips, sawdust, straw, pasture, alfalfa , palm leaf and so on; It can also used to make grass pellets.
Main features of biomass fuel wood sawdust pellet making mill production line
1.Adopting advanced world famous brand components in pneumatic parts ,electric parts and operation parts. 2.Running in a high automatization and intellectualization,no pollution.
Complete Pellet production line process:
(a) Peeling Process
Wood debarker machine is applicable to peel the log of MDF board and papermaking industry, it is mainly used to peel log, small wood and so on, the peeled rate is more than 95 percent.
(b)Chipping Process
In the pellet plant before raw materials are made into biomass pellets, they are
first reduced into much smaller, uniformly-sized particles. When the thicknedd is larger than 10mm or the size is greater than 50*50mm, a chippper is needed to chip these materials into smaller pieces.
(c)Grinding Process
The hammer mill is used to further crush these small pieces into particles of less than 3mm in diameter.
(d)Drying Process
After raw materials are crushed a dryer is needed since most raw wood materials have a moisture content of about 50%. However, the optimal moisture content for pelletiztion is 13%-15%. Therefore a rotary dryer is included in the pellet plant to reduce the
moisture content. After crushing and drying you can begin making wood pellets.
(e)Pelletizing Process
After crushing and drying the raw material properly it is then ready for the pellet mill. The pelletizing machine or press is the key piece of machinery in the pellet plant.
It should be mentioned that impurities in the raw materials like metal or stone,may damage the die and rollers of pellet making machine.
(f)Cooling Process
Usually after pelletizing, the temperature of pellets is between 60-80 degrees and the moisture content is close to 15%. For storage purpose, a cooler must be used to reduce their surface temperature and moisture content.
(g)Packing Process
Finally is the packing process. In order to protect the wood pellets becoming getting
damp and to increase storability, proper packing is necessary.
FDSP Cheap CE 2t/h biomass fuel wood sawdust pellet making mill production line